Advertisement
ASSEMBLY
4
Attach the Back Panel
aligning the eyelets on the back of the Back Panel with
the eyelets near the rear of the arms of the Side
G
Panels. Insert a Bolt
aligned sets of eyelets.
Attach the Back Panel to the Seat Panel by aligning the
holes at the bottom of the Back Panel with the eyelets
near the rear of the Seat Panel. From the underside of
the Seat Panel, insert a Bolt
each of the aligned eyelets/holes.
Tighten all Bolts using the Hex Key but do not over-
tighten.
hardware used:
5
Check all hardware. Adjust and tighten where
necessary for a secure connection, but do not
over-tighten.
Your Bondi Chair is fully assembled!
Contact us for assistance: (866) 985-7877 | www.balkenehome.com
to both Side Panels by
F
I
with Washer
into each of the
H
with Washer
I
into
G
Bolt (M6x20) x2
H
Bolt (M6x30) x2
I
Washer x4
E
B
G
I
I
H
5
Advertisement
