Advertisement
ASSEMBLY
1
Locate the Right Side Panel
the open side facing up and the feet towards you. Place a
Washer
I
on each of 5 Bolts
the Right Side Panel as shown. Align the eyelets on each
panel and insert a Bolt with Washer through each of the 2
aligned eyelets and gently tighten. Position the Front Base
Panel
C
as shown and secure to the Side Panel and Seat
Panel using 3 Bolts with Washers.
Tighten using the Hex Key but do not over-tighten.
hardware used:
2
Attach the Rear Back Panel
the Seat Panel
B
: align the eyelets on the Rear Back Panel
with the eyelets on the already joined panels as shown, then
insert a Bolt
G
with Washer
of eyelets.
Tighten using the Hex Key but do not over-tighten.
hardware used:
3
Locate the Left Side Panel
the open side facing up and the feet towards you. Position
the partially-assembled chair on top of the Left Side Panel
as shown. Place a Washer
eyelets on each panel and insert the 6 Bolts with Washers
through the aligned eyelets as shown.
Tighten using the Hex Key but do not over-tighten.
hardware used:
Contact us for assistance: (866) 985-7877 | www.balkenehome.com
and lay it on a flat surface with
A
G
. Position the Seat Panel
G
Bolt (M6x20) x5
I
Washer x5
to the Right Side Panel
C
I
into each of the 3 aligned sets
G
Bolt (M6x20) x3
I
Washer x3
E
and lay it on a flat surface with
I
G
on each of 6 Bolts
. Align the
G
Bolt (M6x20) x6
I
Washer x6
B
on
G
I
and
A
D
C
B
A
D
B
C
A
A
C
G
E
I
G
I
4
Advertisement
