Advertisement
RESET INSTRUCTIONS
This heater is equipped with an internal high limit switch, which causes the unit to
stop operating in the event the internal temperature exceeds normal operating
temperatures.
IF THE UNIT SHUTS DOWN:
1) TURN THE UNIT OFF
2) UNPLUG UNIT AND WAIT 10 MINUTES
3) PLUG IN AND TURN ON
IF YOUR HEATER FAILS TO OPERATE:
Be sure it is plugged in and that the electrical outlet is working.
Check for any obstruction. If you find an obstruction turn the heater OFF. Unplug
the heater and wait at least ten minutes for it to cool. Carefully remove the
obstruction. Plug the heater back in and restart it as described under OPERATION.
If you still notice the same defect above mentioned, remove the plug from the
socket and have the appliance serviced by authorized service personnel only.
Check that the thermostat is not set too low. With the power switch set to a heat
setting, turn the thermostat up (clockwise) until the heater restarts.
CLEANING AND STORAGE
We recommend that the heater be cleaned at least once a month and before
off-season storage.
Turn the heater OFF and unplug it. Allow it to cool.
Use a dry cloth to clean the external surfaces of the heater.
DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION.
Clean your heater using the above-mentioned steps, then pack the heater in its
original container and store it in a cool dry place.
The motor is factory lubricated for life, and will require no further lubrication.
SPECIFICATIONS
Model No.: 70395000
Voltage: 120V, 60Hz
Current: Maximum 12.5 Amps.
Power: 1500 Watts
Tolerances on all specifications: not exceeded than 105%
6
Advertisement
