Advertisement
ASSEMBLY
Unpack your heater and remove the wheel assemblies from the package. Refer to Fig.
below:
1.
Make sure the heater is unplugged and
in the "OFF" position.
2. Turn the heater upside down.
3. Position the wheel base assemblies
between the end fins as shown.
4. Insert each U-shape screw into the
holes of each wheel holding plate.
5. Insert the butterfly nuts and screw them
tightly.
6. Turn the heater upright.
Your heater is now ready for use.
CAUTION: Risk of fire – Do not operate heater without wheel assemblies attached.
Operate heater in upright position only (wheels on bottom, controls on top). Any
other position could create a hazardous situation.
ELECTRICAL RATINGS
This product is rated 12.5 amps (1500W) at 120V, 60 Hz.
OPERATING INSTRUCTIONS
IMPORTANT!
Your heater is equipped with a polarized
alternating current line plug (a plug having
one blade wider than the other). This plug
will fit into the power outlet only one way.
This is a safety feature. If you are unable
to insert the plug fully into the outlet, try
reversing the plug. If the plug should still
fail to fit, contact your electrician to
replace your outlet.
safety purpose of the polarized plug.
Power Indicator Light
A
safety purpose of the polarized plug.
Power and Setting Control
C
DO NOT defeat the
Control Panel Functions
Wheel
holding
plate
A
B
C
D
Thermostat Control
B
Caution Indicator Light
D
4
U-shape
Screw
Advertisement
