IBM EMX0 PCIe Gen3 Installing page 41

to turn on the system to the operating or running state to activate the PCIe connection. Choose from
the following options:
• If your system is managed by an HMC, continue with step "22" on page 27.
• If your system is not managed by an HMC, use the Advanced System Management Interface
(ASMI), continue with step x.
22. If you are using an HMC, complete the following steps:
a) In the navigation area, click the Resources icon
b) In the content pane, select the name of the system to view the actions for that system.
c) To enable the system to power on to the firmware standby state, complete the following steps:
1) In the navigation area, select Properties > Other properties.
2) Select the Power-On Parameters tab.
3) Record the current setting for the Partition start policy field so that you can restore the setting
later in this procedure.
4) Set the Partition start policy field to User-Initiated. Click OK.
d) In the navigation area, select System Actions > Operations > Power on and click OK.
e) In the content area, observe the system that you are working with until the value in the Status
column changes to Standby.
f) To reset the Partition start policy field to its original value, complete the following steps:
1) In the navigation area, select Properties > Other properties.
2) Select thePower-On Parameters tab.
3) Set the Partition start policy field to the value that you recorded earlier.
g) To start any logical partitions that are currently stopped by using an HMC, complete the following
steps:
1) In the navigation area, click the Resources icon
2) Click the system name in which you want to activate the logical partition.
3) Select the logical partition name that you want to activate.
4) In the navigation area, click Actions > Activate.
5) Click Finish.
h) Continue with step "24" on page 28.
23. If you are using an ASMI, complete the following steps:
a) Access the ASMI by using an authority level of administrator or authorized service provider.
b) In the ASMI navigation area, expand Power/Restart Control.
c) Click Power On/Off System.
d) Record the current setting for the Server firmware start policy field so that you can restore the
setting later in this procedure.
e) Set the Server firmware start policy field to Standby (User-Initiated).
f) Click Save settings and power on.
g) Periodically, click Power On/Off System again to refresh the information on the display until the
value of the Current system firmware state field changes to Standby.
h) To reset the Server firmware start policy field to its original value, complete the following steps:
1) In the ASMI navigation area, expand Power/Restart Control.
2) Click Power On/Off System.
, and then select All Systems.
, and then click All Systems.
Installing an EMX0 PCIe Gen3 I/O expansion drawer 27