Connecting The Battery - Toro TimeCutter SW Series Setup Instructions

1

Connecting the Battery

No Parts Required
Procedure
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
1. Locate the battery and negative battery cable.
2. Remove the plastic cap from the negative battery post.
3. Remove the fasteners on the negative battery cable,
and use them to secure the negative battery cable to
the negative battery post
4
3
2
1
6
5
Figure 1
1. Negative battery cable
2. Wing nut
3. Washer
(Figure 1).
G018395
g018395
4. Negative battery post cap
5. Carriage bolt
6. Negative battery post
2
Installing the Rear Hitch
Parts needed for this procedure:
1 Rear hitch
2 Bolt (5/16 x 1 inch)
2 Locknut (5/16 inch)
Procedure
1. Install the bracket to the frame as shown in
2. Torque the bolts between 19.8 and 25.4 N-m (175 and
225 in-lb).
1. Bolts
2
Figure
Figure 2
2. Locknuts
RELEASED Ver-C ©Toro 2016
2.
g028437