Table of Contents
Advertisement
Configuring the Security Switch 6200 System
Configuring
System
Parameters
4-2
Configuration Menu
==================
1) System Parameters
2) User Authentication and Access Control
3) Network Time Protocol (NTP)
4) Domain Name Service (DNS)
5) Simple Network Management Protocol (SNMP)
6) Alarm Monitors
7) Physical Interfaces
8) Tap Interfaces
9) Network Interfaces
10) IP Aliases
11) Static Routes
12) Static ARP Entries
13) Virtual Router Redundancy Protocol (VRRP)
14) Network Interface Module Configuration
X) Exit
To begin your configuration, select the desired option from the main menu.
NOTE: Within this configuration tool, you can type the initial letter of an
option and the press the Tab key to complete the entire string on supported
choices. The Enter key is used to select default values.
This section describes how to change your system settings. Specifically,
how to:
• Change the system host name and domain name
• Change system information
• Change time information
• Enable external access ability
To configure system parameters:
1.
Select Option 1 from the main menu.
The present System Configuration is displayed. For example:
System
======
Host Name
Domain Name
Date and Time
Time Zone
Telnet Server
FTP Server
WEB Timeout
Default Gateway 192.168.10.1
Would You Like to Modify the System Parameters <Y or
N>[N]:
3COM Security Switch 6200 Hardware and Software Users Guide
helios
Mon Apr 07 15:28:27 EDT 2003
enabled
enabled
20
Advertisement
Table of Contents
