Ce Marking; Declaration Of Conformity; Fcc - Bosch Rexroth ctrlX HMI DE0015 Operating Instructions Manual

12/45
Standards
Standard
IEC 60947-5-1
IEC 60947-5-5
ISO13849-1
IEC 13850
Tab. 8-1: Standards used: E-STOP button

8.2 CE marking

8.2.1 Declaration of conformity

The electronic products described in these instructions comply with the require-
ments and the target of the following EU directive and the following harmonized
European standards:
EMC directive 2014/30/EC
The electronic products described in the present instructions are intended for
use in industrial environments and comply with the following requirements:
Standard Title
DIN EN 61000-6-2 Electromagnetic compatibility (EMC)
Part 6-2: Generic standards – Noise immunity for industrial environments (IEC
61000-6-2:2019)
DIN EN 61000-6-4 Electromagnetic compatibility (EMC)
Part 6-4: Generic standards – Emission standard for industrial environments (IEC
61000-6-4:2007+A1:2011)
Tab. 8-2: Standards for electromagnetic compatibility (EMC)
Loss of CE conformity due to modifications at the device
CE marking applies only to the device upon delivery. After modifying
the device, verify the CE conformity.

8.3 FCC

This device was tested and complies with the limit values for a digital device of
class A as per part 15 of the FCC rules. These limit values should ensure an ap-
propriate protection against harmful interferences if the device is operated in an
industrial area. This device creates and uses high-frequency, it can radiate it and
it can cause harmful interferences of the wireless communication if it is not in-
Bosch Rexroth AG R911405731_Edition 02
ctrlX HMI DE0015, DE0021 Multi-Touch
Meaning
Low-voltage switchgear and controlgear – Part 5-1: Control circuit
devices and switching elements – Electromechanical control cir-
cuit devices
Low-voltage switchgear and controlgear - Part 5-5: Control circuit
devices and switching elements - Electrical emergency stop de-
vice with mechanical latching function
Safety of machinery – Safety-related parts of control systems –
Part 1: General principles for design
Safety of machinery — Emergency stop function — Principles for
design
Displays (Housing Devices)