Advertisement
Crushed glass Media
1.
Place crushed glass media onto the burner and burner
screen. See the Installation Instructions supplied with the
fireplace for more information.
NOTICE: Crushed glass should not be placed on the burner
screen area more than one layer deep. Excessive use of crushed
glass may create a greater chance of developing soot on logs.
Do not allow crushed glass to restrict the pilot flame. Do not
place crushed glass in the pilot bracket accessed area.
Decorative Media Kits
1.
Place embers covering all burner ports as shown in the area
below.
2.
Mix remaining decorative media together as desired and
spread across burner screen. Also fill area between the two
pieces of glass.
Final Steps
1.
Re-install the glass door assembly. Test fire to ensure there
is minimal contact between the flame and the logs.
2.
If the test fire is acceptable, re-install the barrier screen/glass
assembly.
3.
If during the test firing there seems to be significant flame
impingement on the cross logs, there are two steps that can
be taken to reduce the impingement:
a. Pivot log left or right to move away from flame.
b. Thin out crushed glass directly under the cross log. This
can reduce the height of the flame directly under the log.
41485-0-0120
CoMPLetINg INStALLAtIoN
TOP VIEW
Page 17
Advertisement
