Door; Unsatisfactory Cleaning And Corrosion - Miele PG 8581 Operating Instructions Manual

Problem
All programme settings reset

Door

Problem
The door is open a fraction
and cannot be closed us-
ing the  button.
Door not closed properly
Warning. Cabinet hot! Open
anyway?
Obstruction sensor

Unsatisfactory cleaning and corrosion

Problem
There are white deposits
on the wash load.
Cause and remedy
This is not a fault.
A user has restored the factory setting for the programme.
Confirm the message with OK.

Cause and remedy
This is not a fault.
The Comfort door lock has opened the door slightly at the
end of the programme.
Open the door. The door can now be closed completely

again using the  button.
Slamming the door can result in problems with the Comfort
door lock.
Open and close the door.

If the same message appears again:
Contact the Miele Customer Service Department.

When pressing the  button, be aware that the
temperature in the wash cabinet is over 70 °C.
 When the door is opened, hot steam and chemical
agents can escape!
Open the door only when strictly necessary.

The door was closed before the door lock rail was fully
retracted.
Open the door.

The door lock rail must be fully retracted before you

close the door again.
Cause and remedy
The water softener is set too low.
Set the water softener to the correct water hardness.

There is no salt in the salt reservoir.
Refill the reactivation salt.

The quality of the water for the final rinse was insufficient.
Use water with a low conductance value.

If the machine is connected to a water softening

cartridge, check it and replace as necessary.
The water from the AD water connection is not sufficiently
softened.
Check the pre-selected water softening units. If

necessary, replace the water softening cartridge with a
new one.
Problem solving guide
121