Cleaning The Machine; Cleaning The Control Panel; Cleaning The Door And The Door Seal; Cleaning The Wash Chamber - Miele PG 8581 Operating Instructions Manual

Cleaning the
control panel
Cleaning the door
and the door seal
Cleaning the
wash chamber
Cleaning the door
front
Preventing
re-soiling

Cleaning the machine

 Never clean the machine or near vicinity with a water hose or a
pressure washer.
 Do not use cleaning agents containing ammonia or thinners on
stainless steel surfaces!
These agents can damage the surface material.
 Do not use any abrasive materials or general-purpose cleaners
to clean the control panel.
These can cause considerable damage to the glass and plastic
surfaces and to the onset control buttons.
Clean the control panel with a damp cloth and a little washing-up

liquid or with a non-abrasive stainless steel cleaner.
Proprietary glass or plastic cleaning agents can also be used to

clean the display.
For surface disinfection use a listed agent recommended by the

manufacturer.
Wipe the door seals regularly with a damp cloth to remove any

soiling.
Seals which are no longer tight or which have suffered damage
must be replaced with new ones by the Miele Customer Service
Department.
Remove any stains from the door sides and hinges.

Regularly clean the groove in the plinth panel under the door with a

damp cloth.
The wash chamber is generally self-cleaning. However, should a
build-up of deposits occur in the chamber, please contact the Miele
Customer Service Department for advice.
To clean the stainless steel front, use a damp cloth with a solution

of washing-up liquid and hot water, or with a non-abrasive cleaning
agent for use on stainless steel.
To help prevent re-soiling of stainless steel surfaces (fingerprints,

etc.), a suitable stainless steel conditioner can be used after
cleaning.
Maintenance
105