Programme Blocks - Miele PG 8581 Operating Instructions Manual

Programme settings
Programme
blocks
90
The wash block sequence is pre-determined and is the same as the
sequence in the programme chart (see "Programme chart").
- Pre-wash 1 to 3
A pre-wash removes coarse soiling and foaming agents.
Main wash 1 2
- and
Depending on the load, cleaning generally takes place at
temperatures between 45 °C and 65 °C with the addition of
appropriate cleaning agent.
Interim rinse 1 4
- to
In the interim rinse stages, the process chemicals from the
previous wash blocks are rinsed off and neutralised where
necessary by adding appropriate neutralising agents.
Final rinse 1 2
- and
To avoid deposits and corrosion on the load, demineralised (DI)
water should preferably be used if available for the final rinse.
Thermal disinfection is carried out in accordance with the A
concept of EN ISO 15883 at temperatures between 80 and 95 °C
with relevant holding times.
Drying
-
Adequate drying reduces the risk of corrosion caused by residual
moisture on the load.
Programme block parameters are accessible only to the Miele
Customer Service Department, with the exception of the
dispensing of rinsing agent and drying parameters.
0