Cisco Catalyst 9400 Series Hardware Installation Manual page 129
Hide thumbs
Also See for Catalyst 9400 Series:
- System management configuration manual (458 pages) ,
- Installation note (32 pages) ,
- Troubleshooting manual (14 pages)
Table of Contents
Advertisement
Removing and Replacing FRUs
1
2
3
4
Step 7
Close the terminal block cover and finger-tighten the captive installation screw (approximately 0.25 Nm).
Lug secured with two nuts
Heat-shrink sleeve on all the wires
Grounding wire
DC-input wire for negative circuit (-B)
5
DC-input wire for positive circuit (+ B)
6
DC-input wire for positive circuit (+A)
7
DC-input wire for negative circuit (- A)
-
-
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
Connecting the DC-Input Wires
123
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
