Connection - Kenwood KOS-V500 Instruction Manual

Connection

Antenna cord is used when
receiving a radio station with
the built-in tuner.
In this case, set "TUNER
source" in <System Setup>
(page 58) to "On".
Connector A
Battery wire (Yellow)
8 6 4 2
Ignition wire (Red)
7 5 3 1
8 6 4 2
7 5 3 1
Connector B
Connect to the vehicle's parking brake
detection switch harness
using the supplied relay connector.
For the sake of safety, be sure to connect the parking sensor.
Connect to the terminal that is grounded when either
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
82 KOS-V500
FM/AM antenna input
A
PRK SW
To vehicle's reverse lamp harness
To steering remote
the telephone rings or during conversation.
To "EXT.AMP.CONT. " terminal of the amplifier
having the external amp control function.
If no connections are made, do not let the cable come out from the tab.
Accessory 4
Wiring harness
(Accessory 2)
Ground wire (Black)
Battery wire
FUSE ( 5A )
(Yellow)
Ignition wire (Red)
Battery wire (Yellow)
To car light control switch
Dimmer control wire (Orange/White)
Parking sensor wire (Light Green)
Reverse sensor wire (Purple/White)
Steering remote control input (Light Blue/Yellow)
Mute wire (Brown)
Power control/ Motor antenna control wire
(Blue/White)
External amplifier control wire (Pink/Black)
Accessory !
Antenna Cord
(ISO–JASO)
(ISO)
FUSE ( 15A )