Vaillant VRT 350 Installation Instructions Manual page 18

8 Operating
Setting level
Installer level → System configuration →
System
Status
Water pressure
Hot water
Controller modules
Heat generator
Status
VF1
HEATING 1
Auto day temp until
Day temperature
Set-back temperature
Flow temp. target.
Flow temp. current
* If there is no fault, the status is OK. If there is a fault, Fault appears here and you can read the fault message in the Fault messages
section.
1) Appears only if the value Analogue is set for the control type.
If the VR 66 is connected, the functions shown in italics are only available for Zone 1 and these are only shown in the display for the
main controller.
18
Values Unit
min. max.
Current value*
Current value bar
℃
Current value
List
Current value
Current value
Current value hr:min
℃
5 30
℃
5 30
℃
Current value
℃
Current value
Increment/Select Factory reset
Software version
Off,
Heating,
DHW
0.5 20
0.5 15
Installation instructions VRT 350 0020131957_01
Setting