Wiring Of The Module - Siemens SIMATIC S7-1500 Manual

Support for selecting hardware components
We recommend you use the TIA Selection Tool for planning your project. The TIA Selection
Tool is available free of charge as a desktop version for download or as a cloud version, refer
to the Internet
selection-tool.html).
3.4

Wiring of the module

Requirement
• The I/O modules are installed on the mounting rail.
• The supply voltage of the station is switched off.
Procedure
1. Plug the two SIMATIC TOP connect connecting cables with the 40-pin IDC connector into
X10 and X11.
Note when plugging:
– ① The nob on the left edge of connector X11
– ② The nob on the right edge of connector X10
2. Guide the SIMATIC TOP connect connecting cables down to the module.
3. Guide a cable tie around the module at the fixing points and connect the SIMATIC TOP
connect cables.
Digital output module DQ 64x24VDC/0.3A BA (6ES7522-1BP00-0AA0)
Equipment Manual, 07/2020, A5E48024569-AA
(https://new.siemens.com/global/en/products/automation/topic-areas/tia/tia-
Figure 3-3 Connect the SIMATIC TOP connect 40-pin connecting cable to the module
Wiring
3.4 Wiring of the module
15