Attachment Guidelines - Recom RCM-6MB Series Installation And Safety Instructions

Attachment Guidelines

Select the proper installation method depending on the mounting method and the load (See Fig. 1 for more
detailed information).
1 Mounting holes
Secure the module to the frame structure using the module mounting holes. A set of one stainless steel
M6 bolt, one nut, two washers and two lock washers is recommended for each hole. Refer to Fig. 1 for
location of holes.
2 Clamps
The module may be fastened to the support frame by using clamps on the long or short side of the mod-
ule frame. Refer to Fig. 1 for instructions.
3 Insertion system
The module may be mounted on the support by using an appropriate insertion system with or without
additional clamps. The insertion system may fasten the long or the short side of the module frame. Refer
to Fig. 1 for instructions.
• The design load is 2,400 Pascal (Pa) for wind uplift and up to 5,400 Pascal (Pa) for snow (static) load.
• Refer to Fig. 1 for the static design loads of each mounting configuration. The installation methods
applicable for 5,400 Pa are also valid for 3,800 Pa and 2,400 Pa. The installation methods applicable
for 3,800 Pa are also valid for 2,400 Pa.
Installation Instructions IEC / Rev. 05-2018 V.5
RECOM © Copyright 2018
IEC INSTALLATION GUIDE
p. 8 of 14
www.recom-solar.com