• The adjustments during camera setting may be
hindered depending on the camera installation
position. Do not install the camera securely but
attach it only temporarily until the camera setting has
Recommended Installation Position
Examples of correct camera installation
The CMOS-300 should be installed at a
height of 55 cm (21.7 inch) or more.
Installing the Camera/Adjusting its
Decide the camera installation position.
Clean the camera installation surface.
Using a commercially available cleaner, wipe dirt,
moisture and oil away from the surface on which
the camera bracket is to be attached.
Loosen the camera bracket retaining screws.
Using a commercially
screwdriver, loosen the two
Perform steps 4 and 5 only when they are required.
Mount so that the
"KENWOOD" logo appears at
If required, separate the camera bracket from
the camera and adjust the shape according to
the surface on which it will be attached.
Mount the camera on the camera bracket.
Mount so that the "KENWOOD" logo appears at the
Fix the camera temporarily with tape, etc.
Using a piece of tape, etc., ﬁ x the camera
temporarily and adjust the angles so that the rear
end of the vehicle can be viewed.
Attach the camera on the rear center position of
the vehicle taking care not to hide the license plate.
Make sure that the camera points straight toward
the rear of the vehicle travel direction. Be careful
not to lean the camera toward other directions of
the vehicle, etc.
Complete all of the required connections.
Display the camera video.
Some video monitors may switch automatically to
the external video input function. For details, read
the instruction manual for your video monitor.
Change the shift lever to the R (Reverse) range
to view the image of the rear of the vehicle.
Before viewing the camera, apply the parking brake
and chock the wheels so that the vehicle will not
move. Otherwise, an unexpected accident may
Adjust the camera
bracket shape so
that it ﬁ ts the camera