Navico Simrad RS100 User Manual page 66

AIS Class-B (NRS-2 only)
Issue
1
2
AIS won't TX
3
4
5
DSC / ATIS
Issue
1
2
DSC is off
3
4
5
ATIS is off
6
7
Digital noise each
8
time I release PTT
HS100, H100
Issue
1
Handset screen
blank
2
VHF/AIS antennas
Issue
1 Antenna cross-
talk
2
Communication
in one direction
but not the other
VHF Radio Help and Troubleshooting Guide |
Reason
No AIS Antenna
AIS details not completed
No MMSI
No GPS fix
Silent Switch is ON
Reason
No MMSI
DSC function turned OFF
ATIS is ON
ATIS function not
available on my system
No MMSI
ATIS function turned OFF
DSC is ON
Radio has ATIS function
turned ON
Reason
System not turned ON
Contrast setting too low
Reason
Antennas too close to
each other
Obstruction on one side
of the antenna
RS100 / RS100-B / V100 / V100-B User Manual
Details
A VHF antenna must be connected to the AIS
antenna port
All details in the AIS setup screen must be
completed before the AIS system can commence
transmitting.
A valid MMSI must be added before the AIS
system can commence transmitting
A GPS fix must be obtained
The AIS system will receive but not transmit while
Silent mode is active. Set Silent Switch to OFF
Details
You must enter a valid MMSI before DSC can be
used
Turn DSC function ON.
ATIS is turned ON. ATIS and DSC cannot be ON at
the same time.
ATIS is only available on EU models
You must enter a valid MMSI before DSC can be
used
Turn ATIS function ON.
DSC is turned ON. ATIS and DSC can ot be ON at
the same time.
Only use ATIS function while navigating in
European waterways. Turn ATIS OFF otherwise.
Details
System must first be turned ON from any fixed
handset.
Adjust in Contrast menu. It may be difficult to get
to the Contrast menu if you are not able to see
the screen. It will be easier to follow your steps
when viewing on a second handset.
Details
Ensure adequate separation between antennas
Having an obstruction such as an exhaust stack
or sail mast on one side of the antenna can
interfere with transmissions and reception from
that direction.
| 66