Navico Simrad RS100 User Manual page 57

Cable Grommets
There are two cable sealing rubber grommets at the front of the Blackbox. Wires must pass through the
allocated slot in the grommet (L1-7 and R1-7) as indicated to create an IPx5 seal.
Slots have a thin rubber membrane to ensure unused slots remain sealed.
Press the wire through the allocated slot to break the seal prior to adding the connector.
To access the rubber grommets, remove the grommet retainer bracket.
Ensure the grommet retainer and connector cover is replaced once the wiring is completed.
¼ Note:
The connectors are color coded to help you with the installation.
Installation | RS100 / RS100-B / V100 / V100-B User Manual
1 2 3
6
7
4 5
L
2 1
3
6
7
4
5
R
| 57