Midea HD-663W User Manual page 13

15 Adjust the leveling bracket to ensure the ice maker
assembly is totally level.
The ice maker will be level when the gap between the freezer
wall and the ice maker assembly is the same at the top and
bottom.
Once completely level, tighten the leveling bracket screw.
16 Reinstall the freezer shelf below the ice maker assembly.
Set the ice container below the ice maker assembly.
17 Connect the wiring harness to the water valve as shown.
Ensure the connection is secure.
18 Install the mounting box on the connecting terminal
of the water valve and the wiring harness. After the
cover is closed, fix the box cover and the mounting
box firmly with screws.
19 Locate the factory punched holes at the lower right
panel on the rear of the refrigerator.
20 Push up the white plastic ring at the bottom of th
valve until it doesn't move, then insert the water
pipe into it and loosen the plastic ring.
Secure the plastic water tubing to the rear of the
21
refrigerator cabinet with the two (2) plastic clamps
provided.
** NOTE **
Clean the area of the back of the unit where you will be placing
the plastic clamp with household cleaner, ammonia or alcohol
to provide a clean surface for the adhesive to adhere to.
11
(10) Water valve
(12) Box cover
(13) Mounting box
(3) Plastic Water Supply Tubing