Mounting The Product To Place - Beko ARI 7757186301 Service Manual

5.5. Mounting the Product to Place

If the product is mounted on the top of a drawer, bottom side must be protected by furniture as
seen below.
1 min. 25 mm
While mounting the built in hob above a cabinet, please refer to the picture below..
If the built in hob bottom;
* min.
At least 180 cm2 air gap is required at the back of the furniture.
* min.
During the installation of an induction built in hob, place the product in parallel to the
mounting surface. A seal should be applied between built in hob and bench to prevent any
liquid pass.
TR | 11