Preparation; Prepare.the.remote.control; Setting.up.the.player - Toshiba BDX1100KU Owner's Manual

4 Preparation

Always.follow.the.instructions.in.this.chapter.
in.sequence.
Note:
- Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Prepare the remote control
1.Open.the.battery.compartment.
2.Insert.two.R03.batteries.with.correct.
polarity (+/-) as indicated.
3.Close.the.battery.compartment.
Notes:
- If you are not going to use the remote control
for a long time, remove the batteries.
- Do not use old and new or different types of
batteries in combination.
- Risk of explosion! Keep batteries away from
heat, sunshine or fire. Never discard batteries in
fire.
• The maximum operable ranges from
the unit are as follows.
-.Line.of.sight:.approx..9.m
-.Either.side.of.the.centre:.approx..7.m. .
within.30°
-.Above:.approx..7.m.within.30°
-.Below:.approx..7.m.within.30°
7 m
10
9 m 7 m
Setting up the player
Find the correct viewing channel
1.Press. to.turn.on.this.product.
1
2.Turn.on.the.TV.and.switch.to.the.correct.
video-in.channel.(refer.to.the.TV.user.
manual.on.how.to.select.the.correct.
channel)
Initial Setting
When you turn on this unit for the first time,
you.need.to.follow.these.steps.
1..A.welcome.page.will.be.displayed.when.
this.product.is.powered.on.
2..Press.OK.to.enter.language.setting.
3..Select.your.desired.language,
resolution.and.aspect.ratio.using./,.then.
press.OK.
4..Press.SETUP.to.exit.the.Setup.menu.
Use the SETUP menu
1.Press. SETUP to. display. the. Setup. menu.
when. the. BD. Player. is. playing. or. no. disc..
And.press.SETUP to.exit.the.Setup.menu.
Tip:
- When playing a high-definition sources, must press
button to enter
STOP. SETUP
Select menu display language
.
1 Press.SETUP
[General Setting] menu.is.displayed
2.Select.[Language], then.press 
3.Select.[OSD], then.press .
....-.The.language.options.may.vary.for.
different.regions.
4.Press / to.select.a.language,.then.
press OK
Note:
- If this disc player is connected to a HDMI CEC
compliant TV, skip this setting. It switches
automatically to the same OSD menu language
as per your TV setting.
.
interface.