Storing And Returning To Service; Storing Your Vehicle; Returning To Service - Taylor-Dunn TT-316 36AC Operator's Manual

Table of Contents

Advertisement

TT-316-07

Storing and Returning to Service

Both storing your vehicle and returning it to service should only be performed by authorized
personnel.

Storing Your Vehicle

• Clean the batteries, then fill and charge before
putting the vehicle in storage. Do not store batteries
in a discharged condition.
• Lube all grease fittings.
• Clean, dry, and check all exposed electrical
connections.
• Inflate the tires to proper pressure (if applicable).
• For extended storage, the vehicle should be elevated
so that the tires are not touching the ground.
If stored for a prolonged period, the battery should be charged as follows:
Storage Temperature
(F)
Over 60
Between 40 and 60
Below 40

Returning to Service

• Check the battery state of charge and charge if required.
• Perform all applicable maintenance checks in the Maintenance Schedule.
• Remove any blocks from the vehicle and/or place the vehicle down on to the ground.
• Test drive before putting into normal service.
TT-316 Curtis AC System Operator Manual
Charging Interval (months)
1
2
6
NOTICE
Storing batteries that are
discharged or allowing stored
batteries to discharge while in
storage causes sulphation of the
battery plates. This will result in
reduced capacity and premature
failure of the batteries.
Page 35

Advertisement

Table of Contents
loading

This manual is also suitable for:

212037

Table of Contents