Rear Cleansing, Front Cleansing And Wand - Toto WASHLET RG TCF34270GEU Instruction Manual

Reference
Troubleshooting

Rear Cleansing, Front Cleansing and Wand

Trouble
The wand (or cleansing water)
does not come out
The wand extends but the
cleansing water does not come
out / The cleansing water pres-
sure is weak
The cleansing water is cold
Wash functions stop unintention-
ally during use
*1 Except TCF34170GEU, TCF34120GEU and TCF34120GGB.
54
When the temperature is low, it takes time for the wand to come out after the remote
control button is pressed because the water must be warmed up first.
Has the toilet been sat "ON" and used continuously for 2 hours or longer? (If so,
operation is stopped for safety purposes.)
 Stand up from the seat and then use again.
If the water supply pressure drops significantly, for example if water is used else-
where or if there is a water failure, the function may stop for safety.
 Turn the power OFF and wait about 10 seconds before turning the power ON again.
(  Pages 15 –17)
If the above symptom reappears
There may be a malfunction.
Consult with TOTO Service. (  see contact information on the back cover)
The seat switch will not turn on unless you sit on the seat properly.
 Sit back on the toilet seat. (  Page 11)
Are you using a toilet seat cover, a toilet lid cover or a seat
for infants?
 Remove any covers. When using a seat for infants or a
soft highchair, remove after each use. (  Page 10)
Are you pressing "Wand CLEAN" button?
When you press "Wand CLEAN" button, "EWATER+" comes out from the
vicinity of the wand to clean the wand.
 To clean the wand with it extended, perform "Wand cleaning". (  Page 36)
Has a water failure occurred?
 Press "Stop" button on the remote control and wait until water service is re-
stored.
Is the shutoff valve closed?
 Fully open the shutoff valve. (  Page 17)
Perform Descaling mode. (  Page 41)
Is the water pressure set to a low level? (  Page 19)
Is the warm water temperature set to "OFF" or a low level? (  Page 22)
When the temperature of the water supply or the bathroom is low, the water tem-
perature may be low when first sprayed.
"Rear cleansing", "Rear soft cleansing" and "Front cleansing" stop automatically
after 5 minutes of continuous use.
Then the "Power" LED (Green) and the "Energy saver" LED (Green) on the display
of the main unit flash about 60 seconds while hot water is prepared.
 Wait until the LEDs on the display of the main unit light up solidly and then press
the button again.
Does the seat switch have difficulty detecting?
 Sit back on the toilet seat. If you get up slightly from the seat, or sit forward on the
seat, the seating switch may temporarily stop detecting your presence.
(  Page 11)
Please check
Covers