Special Characteristics; Preparations For Use; Placing The Heated Underblanket; Switching On / Off / Selecting The Temperature - Silvercrest SWUB 85 D3 Operating Instructions And Safety Advice

Safety system / Special characteristics / Preparations for use
full area by switching it off automatically in the event
of a fault. If the safety system switches the heated
underblanket off automatically due to a fault, then
the function indicator
2
ceases to illuminate, even if the heated underblanket
is switched on.
Under no circumstances should you connect the
defective heated underblanket to another switch
of the same type. This would also result in a
permanent shutdown by the safety system in
the switch.
Please note that, for safety reasons, the heated
underblanket must not be used in the event of
a fault and must be sent to the service centre
address given below.

Special characteristics

This heated underblanket has been provided with an
especially soft and hygienic soft nonwoven fabric.
The textiles used in this heated underblanket meet
the high human ecological safety requirements of
the Oeko-Tex Standard 100 as proven in tests at the
Hohenstein Research Institute.

Preparations for use

Placing the heated
underblanket
Starting at the foot end, spread out the heated
underblanket (top, see Fig. B) over the mattress.
The plug-in connector
ket should be towards the head end (see Fig. C).
First connect the control unit
underblanket by plugging the two parts of the
plug-in connector
RISK OF DAMAGE TO THE
PRODUCT AND / OR OTHER
PROPERTY! Please be sure
– the plug-in connector and the cable do not
get pinched on the bedframe.
– the cable does not get wedged between the
bedframe and the mattress.
20 GB/IE
on the control unit
1
on the heated underblan-
5
to the heated
1
together (see Fig. D).
5
– the cable does not get severely kinked.
Otherwise the plug-in connector and the
cable could be damaged.
Then place the bottom sheet as usual over
the heated underblanket, so that the heated un-
derblanket lies between the mattress and
the bottom sheet.
Ensure that the heated underblanket is com-
pletely flat and that it does not become drawn
together or folded during use.
Before use on an adjustable bed, verify the
heated underblanket and the cables will not be
pinched in the hinges, for example, or pushed
together.
Switch the heated underblanket on approxi-
mately 30 minutes before going to bed and
cover it with the top sheet and other bedding.
By doing this you will keep all the heat in.
Switching on / off / Selecting
the temperature
Switching on:
Using the temperature setting switch
control unit , set the temperature to setting
1
1, 2, 3, 4, 5 or 6 to switch on the heated under-
blanket. The function indicator
Switching off:
Using the temperature setting switch
control unit , set the temperature to setting 0
1
to switch off the heated underblanket. The
function indicator
2
Selecting the temperature:
This heated underblanket has a rapid heat-up
feature. Set the control unit to the highest tem-
perature setting (setting 6). This will cause the
heated underblanket to warm up quickly.
ing the heated underblanket for
several hours, we recommend set-
ting the control unit
on the
3
illuminates.
2
on the
3
ceases to illuminate.
When operat-
to the lowest
1