3.
Select the Input.
When an Output has been selected, all Input buttons pressed thereafter will switch to that output. This is
indicated by the blue line highlighting the current output selection.
Protecting Outputs
The
button is used to lock the current output (destination) from switching by other control panels or virtual
Protect
control panels. If a switch is attempted for an output that has been protected, a message is displayed describing the
cause of the error.
• Clicking
once will protect the current destination.
Protect
• Clicking
a second time will clear the protect.
Protect
Machine Control
The Machine Control button (MC) is used to reciprocally switch the source (master) and destination (slave)
selected. Click MC to enable machine control operation and then press the required destination and source.
For More Information on...
• the Machine Control operation and reciprocal switching, refer to the NK Series User Guide.
NK-IPS Installation Guide (v5.0)
Using an NK-VCP • 35