Contents Page General Preparation Overview Wall Mounting Ceiling Mounting Window Mounting Wiring Appliance Fan Specifications Wiring Specifications SELV Box Installation Commissioning/Setup Servicing/Maintenance To disassemble the unit, disconnect from mains supply and use a screwdriver to segregate the electronic components and motor from the plastic housing. Dispose items in accordance with WEEE.
General Preparation - read all instructions before commencing Warning: This appliance can be used by children aged from 1.1.0 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Overview 2.1.0 Greenwood’s Samika fan range has been designed to offer a simplistic approach to meet Building Regulations and provide an energy efficient domestic ventilation solution to improve indoor air quality in dwellings. The fan may incorporate fully automated integral controls which monitors the homeowners’...
Wall Mounting - Using ED wall duct and EG external grille 3.1.0 Rotate discreet front cover to the left and pull off. Loosen retaining screws at the bottom of the internal grille and lift off. 3.1.1 Cut the duct to width of the plasterboard (A) LE 100 Ø...
Ceiling Mounting 4.1.0 Rotate discreet front cover to the left and pull off. Backdraught Shutters Loosen retaining screws at the bottom of the internal grille and lift off. 4.1.1 Cut an opening through the ceiling for the fan and electric cable. Ø...
Window Mounting 5.1.0 Rotate discreet front cover to the left and pull off. Backdraught Shutters Loosen retaining screws at the bottom of the internal grille and lift off. Remove backdraught shutters and discard. 5.1.1 Cut circular hole within window pane. LE100 Ø...
Wiring Appliance WARNING: Installation or disconnection must be carried out 6.1.0 by a qualified Electrician and all wiring must conform to IEE Wiring or local regulations. The appliance must be isolated from the mains supply before removing the electronics cover. 6.1.1 Strip cable to correct lengths as shown.
8.0 Wiring Specification WARNING: Isolate electricity supply before starting work. 8.1.0 The electrical connections must be carried out by a qualified Electrician in accordance with IEE or local regulations. 8.1.1 The 230V fan is double insulated and does not require an earth. 8.1.2 The SELV fan is Class III and does not require an earth.
SELV Box Installation 9.1.0 Install SELV Back Plate and Power Supply, using the two fixing holes, in a suitable location outside of the room where the Samika SELV fan (LE100SVT/LE100SVHT) is installed. The location should be as such that air can circulate around the Power Supply unit and it should never be covered.
10.0 Commissioning / Set-up 10.1.0 Press the + or – button to identify speed that the fan has been set to. 10.1.1 Press + or - button to increase/decrease fan to desired installed airflow requirement. 10.1.2 The 3 LED lights on the right hand side of the control panel will change to indicate speed setting.
Need help?
Do you have a question about the Samika LE100 and is the answer not in the manual?
Questions and answers