Zoom G1 Service Manual page 5

Inspection judgment standard of 16 click setting.
①③⑤～⑮⑰⑲
※A value changes in
a range of arrow
0->1、2->1
13->14、15->14
Attention at the time
of setting
↓
It must
consciously setting
that center of
allowance.
3. Knob
Turn the [VALUE] knob (SW6) and 7 segment LED indicates "00–FF".
Make sure that indication smoothly changes in the range of "00-FF" and the value
changes 1 step by 1 detent.
4. Flash rom
Press the [BANK UP・TAP] key (SW1).
Make sure that "ok" appears on the 7 segment LED.
If any error occurs, "nG" is indicated on the 7 segment LED.
5. Product number
1)Press the FOOT SWITCH [^] (SW5).
Make sure that "G1" is indicated on the 7 segment LED.
2) Press the FOOT SWITCH [^] (SW5) again.
Make sure that "9b" is indicated on the 7 segment LED.
6. Foot pedal
1) Connect FP-01 or FP-02 with CONTROL IN connector (J1).
2) Move the expression pedal.
Make sure that the values on the display change as follows.
⑦
⑥
⑤
It is OK to change with a
dark color.
③
There is a change in
a click
（allowance）＝
NG
①
It is OK to change with a
dark color.
Figure 1.16 clicks value confirmation position
Expression pedal
MIN (raised)
MAX (down)
- 5 -
⑩
⑨
⑧
7
6
5
②④⑯⑱
4
※It is NG that a
value changes in a
3
click.
④
2
②
1
0
Values
05–0C
E3–FF
⑪
⑫
8
9
⑬
10
11
⑭
12
⑯
⑮
13
⑱
14 ⑰
15
⑲