Dealer Service & Adjustment; Dealer Service Introduction; Important Maintenance Tips; C.cleaning - Sunrise Medical Quickie XTENDER Owner's Manual

Q UI C KI E XT ENDER
The owner of this unit is responsible for makiing sure that it has been setup and adjusted by a trained service
professional. Service and/or adjustments should only be done by a professional. Always use parts and/or
accessories that have been recommended and approved by Sunrise Medical when servicing this unit.

DEALER SERVICE INTRODUCTION

A.
1. At least once per year, this unit should have a complete inspection, safety check, and regular service
made by an authorized dealer.
2. Torque settings– A torque setting is the optimum tightening which should be made on a particular
fastener. It is important to use proper torque settings where specified. When not specified, torque
settings should be 62 in-lbs.
3. If you have discovered a worn, bent, or damaged part, repair or replace them with recommended
parts before returning this unit to service.
4. All major maintenance and repair work should be done by an authorized dealer.

IMPORTANT MAINTENANCE TIPS

B.
1. Torque settings:
A torque setting is the optimum tightening which should be made on a particular fastener. It is important to
use proper torque settings where specified. When not specified, torque settings should be 62 in-lbs.
2. Dealer service and adjustment reference materials:
For help with maintenance go to www.sunrisemedical.com for parts manuals, owner's manuals, and
instruction sheets that will aid in the repair and maintenance of the Quickie Xtender.
You may also refer to the following documents:
1) Yamaha JWX-2 service manual
2) Your wheelchair owner's manual
C. CLEANING
1. Paint Finish
a. Clean the painted surfaces with mild soap or detergent.
b. Protect the paint with a coat of non-abrasive auto wax.
2. Axles and Moving Parts
a. Clean around axles and moving parts with a slightly damp (not wet) cloth.
b. Wipe off or blow away any fluff, dust or dirt on axles or moving parts.
D. INSPECT
1. Final inspection instructions:
After the unit is assembled and adjusted, it should roll smoothly and easily. All accessories should also
perform smoothly. If you have any problems, follow these procedures:
1. Review the set-up and check-out sections and operating guide to make sure the unit was properly
prepared, and installed correctly on your chair.
2. Review any troubleshooting information in this manual.
3. If you determine that a problem exists, contact your authorized dealer. If you still have a problem
after contacting your authorized dealer, contact Sunrise customer service. See the Introduction
Page for details on how to contact your authorized dealer or Sunrise customer service.
WARNING
13
IX. DEALER SERVICE AND ADJUSTMENT
MK-100156 Rev. C