Cambo AC-371 Instruction Manual page 4

3. Reassembling the rear standard
Figure 3. Installing the rear tilt unit.
Start by installing the rear base tilt unit [7] to the Actus rail. Remove the M2x4
[5] from the rear base tilt unit by using the supplied 1,5mm Allen key [6]. Slide
the rear base tilt unit over the rail until the rear base tilt unit reaches the end
stop. Now slide the rear standard [4] over the rear base tilt unit and align the
mounting hole of the rear standard to the threaded hole in the rear base tilt
unit. Fit the earlier removed M2x4 bolt [5] to the rear base tilt unit using the
Allen key [6]. For adjusting the rear base tilt unit see chapter 5.
4