After Operation; After Operation Safety; Using The Fuel-Shutoff Valve; Pushing The Machine By Hand - Toro Z Master Professional 7000 Series Operator's Manual

After Operation

After Operation Safety

General Safety
•
Park machine on level ground, disengage drives,
set parking brake, stop engine, and remove
key. Wait for all movement to stop and allow
the machine to cool before adjusting, cleaning,
repairing, or storing. Never allow untrained
personnel to service machine.
•
Clean the machine as stated in the Maintenance
section. Keep engine and engine area free from
accumulation of grass, leaves, excessive grease
or oil, and other debris which can accumulate
in these areas. These materials can become
combustible and may result in a fire.
•
Frequently check for worn or deteriorating
components that could create a hazard. Tighten
loose hardware.
Using the Fuel-Shutoff
Valve
The fuel-shutoff valve is located under the seat. Move
the seat forward to access it.
Close the fuel-shutoff valve for transport, maintenance,
and storage.
Ensure that the fuel-shutoff valve is open when
starting the engine.
Figure 34
1. O position
N
g008948
2. O position
FF
Pushing the Machine by
Hand
Important:
Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
Pushing the Machine
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Rotate the bypass valves counterclockwise 1
turn to push (Figure
Note:
This allows hydraulic fluid to bypass the
pump enabling the wheels to turn.
Important:
Do not rotate bypass valves
more than 1 turn. This prevents valves from
coming out of the body and causing fluid to
run out.
4. Disengage the parking brake before pushing.
33
35).