Toro Z Master Professional 7000 Series Operator's Manual page 69

to Adjusting the Front-to-Rear Mower Deck
Pitch (page 70).
•
If a front chain is loose, raise (tighten) the
front-support arm for that chain; refer to
Adjusting the Front-to-Rear Mower Deck
Pitch (page 70).
Leveling the Mower Deck
Side-to-Side
1. Position the right blade side-to-side
1. Measure here from blade
to hard surface
2. Measure the right blade at the B location, from
a level surface to the cutting edge of the blade
tip (Figure 99).
3. Record this measurement. This measurement
needs to be 80 to 83 mm (3-1/8 to 3-1/4 inches).
4. Position the left blade side-to-side
5. Measure the left blade at the C location
99), from a level surface to the cutting edge of
the blade tip.
6. Record this measurement. This measurement
needs to be 80 to 83 mm (3-1/8 to 3-1/4 inches).
7. If the measurements at positions B or C are not
correct, loosen the bolt attaching the rear chain
to the rear-support arm
(Figure
Figure 99
2. Measure at B and C
(Figure
(Figure 100).
99).
1. Rear chain
2. Rear-support arm
3. Bolt
4. Jam nut
8. Loosen the jam nut under the rear-support
arm and adjust the adjustment bolt to get a
measurement of 80 to 83 mm (3-1/8 to 3-1/4
inches); refer to
Note:
g006888
mower are adjusted the same distance.
9. Tighten the jam nut under the rear-support arm
and tighten the bolt securing the chain to the
rear-support arm.
10. Adjust the opposite side if needed.
99).
(Figure
69
Figure 100
5. Adjustment bolt
6. Front swivel
7. Front-support arm
Figure 100.
It is recommended that both sides of the
g001040