Toro Z Master Professional 7000 Series Operator's Manual page 65

Setting the Left Hydraulic Pump
Neutral Position
1. Loosen the locknuts at the ball joints on the
pump control rod
2. Start the engine, open the throttle 1/2 way and
disengage parking brake; refer to
the Parking Brake (page
Note:
The motion-control lever must be in
neutral while making any adjustments.
Note:
The front nut on the pump rod has
left-hand threads.
3. Adjust the pump rod length by rotating double
nuts on rod, in the appropriate direction, until
wheel is still or slightly creeps in reverse
88).
4. Move the motion-control lever forward and
reverse, then back to neutral. The wheel must
stop turning or slightly creep in reverse.
5. Open the throttle to fast. Make sure that the
wheel remains stopped or slightly creeps in
reverse, adjust if necessary.
6. Tighten the locknuts at the ball joints
Figure 88
1. Double nuts
2. Pump rod
3. Adjustment bolt
(Figure 88).
Disengaging
25).
(Figure
4. Locknut
5. Ball joint
6. Pumps
WARNING
The electrical system does not perform
proper safety shut off with the jumper
wire installed.
• Remove the jumper wire from the
wire harness connector and plug the
connector into the seat switch when
you complete the adjustment.
• Never operate the machine with the
jumper installed and the seat switch
bypassed.
7. After both pump neutrals are set, shut off the
machine.
(Figure
8. Remove the jumper wire from the wire harness
connector and plug the connector into the seat
switch.
9. Install the seat rod and lower the seat into
position.
10. Remove the jack stands.
88).
g001066
65