Adjusting The Self-Propel Drive - Toro Super Recycler 20382 Operator's Manual

Figure 38
4. Remove the blade, saving all mounting
hardware.
5. Install the new blade and all mounting hardware.
Important:
Position the curved ends of the
blade to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt
to 82 N-m (60 ft-lb).
Important:
A bolt torqued to 82 N-m (60
ft-lb) is very tight. While holding the blade
with a block of wood, put your weight
behind the ratchet or wrench and tighten the
bolt securely. This bolt is very difficult to
overtighten.
Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1. Turn the adjustment knob counterclockwise to
loosen the cable adjustment
g003235
1. Handle (left side)
2. Adjustment knob
2. Adjust the tension on the cable
pulling it back or pushing it forward and holding
that position.
Note:
Push the cable toward the engine to
increase the traction; pull the cable away from
the engine to decrease the traction.
3. Turn the adjustment knob clockwise to tighten
the cable adjustment.
Note:
Tighten the knob firmly by hand.
19
(Figure 39).
Figure 39
3. Self-propel-drive cable
(Figure
g027709
39) by