Lubricating The Wheel Gears; Replacing The Blade - Toro Super Recycler 20382 Operator's Manual

Figure 36
•
If the oil level is too low, add a small amount
of oil slowly to the oil-fill tube, and then
repeat steps 6
the dipstick is correct.
•
If the oil level is too high, drain the excess oil
until the oil level on the dipstick is correct.
Important:
If the oil level in the crankcase
is too low or too high and you run the
engine, you may damage the engine.
9. Install the dipstick securely.
10. Recycle the used oil properly.
through 8 until the oil level on
Lubricating the Wheel
Gears
Service Interval: Every 25 hours
1. Wipe the grease fittings just inside the rear
wheels with a clean rag
g017491
1. Grease fitting
2. Install a grease gun onto each fitting and
gently apply 2 or 3 pumps of #2 multi-purpose,
lithium-based grease.

Replacing the Blade

Service Interval: Before each use or daily
Every 25 hours—Replace the blade or have it
sharpened (more frequently if the edge dulls
quickly).
Important:
You will need a torque wrench to
install the blade properly. If you do not have a
torque wrench or are uncomfortable performing
this procedure, contact an Authorized Service
Dealer.
Examine the blade whenever you run out of gasoline.
If the blade is damaged or cracked, replace it
immediately. If the blade edge is dull or nicked, have
it sharpened or replace it.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Wear gloves when servicing the blade.
1. Disconnect the spark plug wire from the spark
plug. Refer to
16).
2. Tip the machine onto its side with the dipstick
down.
3. Use a block a wood to hold the blade steady
(Figure 38).
18
(Figure 37).
Figure 37
Preparing for Maintenance (page
g003234