Vantec NST-510S3-BK Installation Manual

Installation Guide
For NST-510S3-BK ( 9.5mm only
Front Plate
USB 3.0 Cable
1.
Verify the package contents.
4.
Slide the Optical drive on the Tray until the Slim SATA interface on
the Optical drive dock completely with the Tray Slim SATA interface.
*Optional USB Power Connection:
If your Optical Drive need more power than 1 USB 3.0
port can provide. please use the additional USB power
connection to your system, If you are not sure connect both.
USB 3.0 Cable
7.
Connect the USB cable to the Optical unit and your system USB port.
The Optical unit is bus powered. It will draw power from the USB port.
Information in this document is subject to change without notice.
Reproduction of these materials in any manner whatsoever without written permission is strictly forbidden.
Printed in China
Printed on Recycled Paper.
) . For NST-520S3-BK ( 12.7mm ) see back page.
2.
Carefully slide out the optical drive tray.
5. Secure the Optical Drive to the Tray using the provided
small screws on both sides.
Optional USB
Power Connection
USB 3.0 Port
8.
The Operating System will detect USB Mass storage device
connected and load the necessary drivers built into the
Operating System. No other drivers are needed.
Side View
If the Front Plate of your Optical Drive is using a Protruding or
3.
Curve Front Plate, please use the provided Front Plate to replace
it. Follow the picture showing the hook to remove and replace.
6. Slide the Tray with the secured optical drive into the
Aluminum housing and secure with two screws.
?
9.
Once the drivers are installed the Optical drive is ready for use.
Copyright © 2015 Vantec Thermal Technologies. All Right Reserved.
USB 3.0 Slim SATA
Optical Drive Enclosure
1) Eject the Optical Tray by inserting a
paper clip into the eject hole on the
front of the Optical drive.
2) Note the location and direction of
the hooks on the provided Flat Front
Plate, unhook each hook slowly.
Flat Front Plate
3) Replace it with the provided Flat
Protruding or
Front Plate back onto your Optical
Curve Front Plate drive. Note the location of the 4 hooks.
OK
Model: NST-510S3-BK
| All Registered Trademarks Belong To Their Respective Companies.