Startup - Princeton VL1919 Manual

➧ Connecting the audio cable
If your computer is equipped with an audio output port, connect one end of the sound cable to the audio
Input connector of the monitor (① in fig. 3) and the other end to the Line-Out connector of the computer.
➧ To connect the monitor to the power source
Connect the separate power cable (② in fig. 3) to the Monitor and a grounded outlet.

STARTUP

1. First start your PC and then turn on your monitor using the power switch (④ in fig. 4). The status
indicator (④ in fig. 4) should light up green.
Adjust the image to meet your requirements (see the following sections "Basic Setup" and
2.
"Image settings using the OSD menu").
3. If there is no image displayed on the monitor, consult the section "Troubleshooting".
Figure 3.Connecting the monitor to the power source
Cable DVI-D
6