Before operating the monitor please read this manual thoroughly. This manual should be retained for future reference. Contents Packing list ------------------------------------------------------ Precautions ------------------------------------------------------ Installation Instructions -------------------------------------- Swivel Base ---------------------------------------------------- Power cord --------------------------------------------------- Video cable --------------------------------------------------- Operating Instructions --------------------------------------- General Instructions --------------------------------------- Front panel control ----------------------------------------- How to adjust a setting ------------------------------------ Adjusting the picture ---------------------------------------...
Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance.
INSTALLATION INSTRUCTIONS Swivel Base To attach the swivel base to the monitor, do the following: • Carefully turn the monitor on its side or upside down. ( see figure 1 ) • Locate the cavities at the bottom front of the monitor. •...
Video cable Connecting the Video Cable: The monitor comes with a built-in video cable. Plug the signal cable's 15-pin connector into the computer's video port and tighten the two screws on the cable connector. Caution: Don’t bend the signal cable, otherwise it will break the inner wire. Connecting the Power Cord: Plug the power cord into the monitor's AC power socket.
OPERATING INSTRUCTIONS General Instructions The other control knobs are located at the base of the monitor (See Figure 3). By changing these settings, the picture can be adjusted to your personal preferences. • The power cord should be connected. • Connect the video cable from the monitor to the video card. •...
Front Panel Control • : Press this knob to switch ON/OFF of monitor’s power. • MENU : Active OSD menu or function adjust confirm. • : Adjust contrast or function adjust. • : Adjust brightness or function adjust. • EXIT : Exit a function or inactive OSD menu. •...
Adjusting the picture The description for functional control icons 1. CONTRAST Adjust the picture contrast. 2. BRIGHTNESS Adjust the picture brightness. 3. H-CENTER Adjust the horizontal position of the picture. 4. H-SIZE Adjust the picture’s horizontal size. 5. V-CENTER Adjust the vertical position of the picture. 6.
16. MOIRE REDUCE Moire is the result of interference between the phosphor layout and the video signal. In some cases, you may find the moire very noticeable. Press the MENU to enter in the moire reduce setting. Please adjust the level to the optimum condition. Note: Too high of a setting will cause the picture to shake.
APPENDIX A - SPECIFICATIONS 43.2cm(17"), 90˚ deflection, 29mm neck, 0.25mm(D), 0.21mm(H) dot pitch non-glare screen Viewable Image Size 40.6cm (16.0"), diagonal Display Color Unlimited colors Input Signal Analog input All timing that meets scanning frequencies • Video • Analog RGB: 0.7Vpp positive/75 ohm •...
Page 12
) Max. 310 mm × 230 mm Preset display area Regulations UL, CSA, FCC, FDA, MPR II As an ENERGY STAR Partner, Princeton Digital (USA) Corp. has determined that this product meets the ENERGY STAR guidelines for energy efficiency.
APPENDIX B – FACTORY PRESET TIMING TABLE HORIZONTAL VERTICAL STANDARD RESOLUTION FREQUENCY FREQUENCY 720 x 400 31.5kHz 70Hz 640 x 480 31.5kHz 60Hz VESA/85 640 x 480 43.3kHz 85Hz VESA/85 800 x 600 53.7kHz 85Hz VESA/85 1024 x 768 68.7kHz 85Hz VESA/60 1280 x 1024...