Cateye PADRONE DIGITAL CC-PA400B Manual page 48

Troubleshooting
PADRONE DIGITAL: Abnormal display
The display remains blank when the button is pressed.
Replace the PADRONE DIGITAL battery as described in
Incorrect data appear.
Press only the AC button on the back of the PADRONE DIGITAL to restart it.
The setting values will be maintained.
Why are measurement values flashing?
If using a Cateye sensor, measured values start flashing to indicate that there is little
remaining battery life in the relevant sensor.
Refer to "Replacing the battery" (Page 45)
replace the battery at the relevant sensor.
Smartphone: Errors when using Cateye Cycling™ app
Cannot connect a paired PADRONE DIGITAL with a Cateye Cycling™ app
Restart Cateye Cycling™ app. If this does not resolve the issue, restart your
smartphone.
The (Import from CC) button is not displayed in the activity screen or the device
screen, and summary data cannot be imported
•
Have you reset the PADRONE DIGITAL?
To import summary data using Cateye Cycling™ app, the PADRONE DIGITAL
must be reset (MODE pressed for longer than 2 seconds on any display other
than Dst2).
•
If the PADRONE DIGITAL was reset but the
Measurements for trips of 0.1 km or less are not recorded as summary data.
Cannot upload data
•
Have you setup the account for each service site?
From (Other) in the Cateye Cycling™ app, tap [Account] and enter the
account information for each site.
"Replacing the battery" (Page
or the sensor's online manual
button is not displayed:
48
Appendix
Introduction
45).
and
Using the unit
Using the app
SET
Appendix
Cover,
1
2
3
4
5
6/8