Table of Contents
Advertisement
6.2
Creating VLAN
Perform the following procedures to create a VLAN.
1
Log on with administrator privileges.
2
Set the port of the switch connected to the Ethernet controller to
enable send/receive of VLAN tag frames.
3
Click [Start] → [Settings] → [Control Panel] → [Intel®PROSet
Wired], and start Intel
4
Select LAN adapter to set VLAN, and right click.
A VLAN cannot be set to an adapter composing a team.
5
Click [Add VLAN].
6
Set [ID] and [Name], then click [OK].
[ID] must be the same as the set values on the switch. The available range to set is 1 to 4094.
[Name] does not need to be the same as the setting on the switch.
When the confirmation message appears, select [Yes].
7
Repeat Steps 4 through 6 to set respective VLANs.
8
Click [OK] and exit Intel
When configuring a VLAN is completed, a virtual adapter "Intel(R) Advanced Network
Services Virtual Adapter" will appear.
Upper layer protocol is bound to this virtual adapter.
You cannot bind them with the Ethernet controller that makes up a Team.
IP address is set in this virtual adapter.
9
Restart the system.
®
PROSet.
®
PROSet.
E
73
6 VLAN
Advertisement
Chapters
Table of Contents
