Advertisement
CAUTION
Static Sensitive Devices
Handle with Care
KNOW YOUR M.2 MODULE SIZE
To install your M.2 SSD module correctly, please follow the steps listed:
M.2 Card
80 mm
22x80 mm
60 mm
42 mm
22x60 mm
22x42 mm
For your M.2 22x80 size,
Use instruction on this page
For your M.2 22x60 or 22x42,
Use instruction on the back page
Push down
4
.
Insert the black screw (SCREW-C) thru NUT-D,
push down the module and secure on to the
enclosure.
This enclosure support SATA SSD using
"B" Key or "B+M" Key.
This enclosure DO NOT support NVMe
or PCIe M-Key Module.
NVMe M-Key
SATA SSD B+M Key
X
AHCI M-Key
SATA SSD B Key
USB-C
X
1
. Verify the package contents.
5
.
Once the M.2 is secured, replace the cover shown.
Note the cover latch. Secure the cover using two
SCREW-E to hold the cover in place.
Note: The connecting direction
of the cable is xed and the
enclosure would not work in
the opposite direction.
USB-C
USB-C
or
USB-A
6
. Connect single end USB-C to your enclosure and
the other end to your computer USB-C or to USB
Type A port ( NOT both ).
USB-C
NUT-A
USB-A
NUT-D
SCREW-B
SCREW-C
2
.
Hold the enclosure at the angle
shown to remove the cover. Note
SCREW-E
the cover latch for locking the
cover on one end.
USB-C
Write-Protect mode
LED Activity :
RED - Read Only mode
White - Read / Write mode
NOTE :
For Write-Protect to function correctly, You MUST adjust
Read Only or Read/Write mode before connecting USB to
Computer.
Copyright © 2020 Vantec Thermal Technologies. All Rights Reserved. All Registered Trademarks Belong to Their Respective Compaines.
M.2 SATA SSD to USB 3.1 Gen 2 Type C Enclosure
3
.
Insert at an angle the M.2 22x80 Module into the M.2
interface with label face up. Insert the NUT-D on to the
semi-circular notch.
LED
Preparing the newly installed SSD for use:
All NEW USB storage needs to be initialized,
partition and formatted for the Operating
System you are using before it can store
data. For Windows OS, use Disk Manage-
ment and for OS X, use Disk Utility.
If the M.2 is not new and have important
data already on the memory module, DO
NOT initialize, it will erase all the DATA.
For detail, instruction refers to the FAQ
"How to preparing a New storage, Hard
Drive, or SSD for use with a system"
on our website support section at
www.vantecusa.com
NST-203C3-SV
v 1.03
Advertisement
