Inserting And Removing Pc Cards; Inserting A Pc Card - Toshiba TE2000 User Manual

76
Connecting Other External Devices

Inserting and removing PC Cards

Inserting and removing PC Cards
Your TE2000 Series computer comes with two stacked PC Card
slots and supports three types of PC Cards:
Type I cards—You can install up to two of these cards, one in
each slot.
Type II cards—You can install up to two of these cards, one in
each slot.
Type III cards—You can install just one of these cards.

Inserting a PC Card

NOTE: Use caution when lifting or turning your computer.
Failure to do so may result in damage to components, such
as cables, attached to your computer, or to the computer
itself.
Before you insert a PC Card, refer to the documentation that
comes with the card to see if you need to do anything before you
insert it.
To insert a PC Card:
1 Turn off the computer.
You may also hot swap a PC Card. Stop the PC Card by
clicking the Safely Remove Hardware icon on the task bar.
After the PC Card is stopped, it is safe to remove.
1 Locate the PC Card slot on the left side of the computer.
2 If the PC Card slots are locked, unlock them by turning the
computer over, locating the PC Card lock and sliding the lock
into the unlocked position.
3 Insert the PC Card.