4019 Digital Phone; Commissioning - Alcatel-Lucent OXO Connect Series Installation Manual

Chapter 4
• If an AOM10 is used with other Add-On Modules, it must be connected as the last module on the far
right of the set.
4.8.1.1.2.2 Connecting Add-On Modules
To connect an Add-On Module:
1. Remove the tab located on the right side of the set.
2. Plug the Add-On Module's SATA connector into the set's SATA connector.
3. Insert the Add-On Module attachments into the appropriate holes located on the right side of the
set. (AOM10 only)
4. Screw the Add-On Module to the set. (AOM10 only)
Note:
If the set is on when you plug in an Add-On Module, you must restart the set after connection.
4.8.1.1.3 Binary file download
To operate correctly, Digital Premium DeskPhones sets require binary files which must comply with the
PBX version and configuration. After system upgrade and each time a set initializes, version numbers
of binary files are verified to determine whether an update of these files is necessary.
When a file is downloaded to set, it overwrites any previously existing file.
Application download to a terminal can be heavy in terms of bandwidth and CPU resources. It is not
possible to upgrade all the terminals during initialization of the system.

4.9 4019 Digital Phone

4.9.1 Commissioning

4.9.1.1 Overview
This module presents all the actions required for commissioning the Alcatel-Lucent 4019 Digital Phone
set.
The following figure illustrates the connectors on the base of the set.
3EH21123USAA - Ed. 01 - April 2017 - Installation Manual
Installation and Cabling
106/207