Troubleshooting - Salente Ario Instruction Manual

TROUBLESHOOTING

PROBLEM
1. Is the Pressure Limiting
Valve (3) on the lid (2)
supposed to be loose?
2. When I choose a Menu
Button (ex: SOUP), nothing
happens? What's wrong?
3. After I set the pressure
cooker it will begin to heat up,
but in about 5-minutes the unit
beeps 3 times and goes to
Keep Warm and my food does
not cook completely. What is
happening?
4. Steam is being released
Yes even though it will have a loose fit it is safely secured. It
will turn 360 degrees. But when pressure has built up, and
the Valve is set to "Sealing" properly, it will resemble a
bobble head.
Nothing is wrong. Make sure the pressure limiting valve (3)
is set to Sealing and the Lid (2) is locked securely. Once you
have selected the Menu Button, simply leave the unit alone
and it will start to heat and build up pressure. Once the unit
has built up enough pressure, the display will change to a
countdown timer that displays your desired cooking time of
the Menu Button you selected. This is the time the unit will
start cooking the food. Pressurizing can take anywhere from
5 minutes to up to 40 minutes depending on the quantity and
weight of food you are cooking.
The unit is detecting that not enough liquid has been added
to your recipe. The pressure cooker has an automatic over-
heat protection sensor that will automatically set itself to
OFF(00:00) or Keep Warm when it detects that not enough
liquid is present so that it does not over-heat. Make sure all
pressure is released, open the lid and add in increments of
1/2 cups of liquid until the unit will properly build up
pressure and cook.
The unit is detecting that there is a leak in the pressure and
that it is not sealed properly. Firmly push down on the lid to
help the seal form or release any built up pressure and safely
remove the lid to check the unit thoroughly. Make sure the
rubber gasket ring is in place, the lid is securely locked, and
that the Valve on top of the lid is set to the "Sealing"
position. Reset the unit by unplugging it. Wait 10-seconds
and plug it back in. Program the unit again.
Both of the above solutions will cause some liquid to have
evaporated and it is recommended to add back in any liquid
that has evaporated otherwise you will keep encountering
the same issue or pressure cooker may not function properly.
Please note that steam escaping from the Valve (3) or
SOLUTION