Toshiba Tecra M2V Series User Manual page 119

To use any of these methods, you first need to enable them in
the TOSHIBA Power Saver utility.
1 Click Start, Control Panel, and then Performance and
Maintenance.
2 In the Performance and Maintenance window, click the
TOSHIBA Power Saver icon.
3 Click the Action Setup tab.
4 Select Standby for the options you want.
When I press the power button
Set this option to Standby to put the computer into
Standby mode when you press the power button.
When I close the lid
Set this option to Standby to put the computer into
Standby mode when you close the display panel.
5 Click OK, then close the Control Panel.
For more information about the Power Saver utility, see
NOTE
Diagnostic Tool" on page
Starting again from Standby mode
To start up the computer from Standby mode, press the power
button until the on/off light changes to green. The computer
returns to the screen you were using.
If you put the computer in Standby mode by closing the
display panel, you can start it again by opening the display
panel.
Learning the Basics
Powering down the computer
172.
119
"PC