Scope Of Delivery; Assembly Instructions; Detachable Control Unit, Mounting Options - Aqua Computer D5 NEXT User And Installation Manual

aqua computer
Save your data onto suitable media before working on your hardware!
●
The pump must not be placed under water!
●
The pump controller on the rear end of the pump must not get in contact
●
with water!
The pump may only be used inside a PC case!
●
The pump is not a suction pump. Make sure the pump chamber is filled with
●
water prior to operation!
The pump is not suited for dry operation!
●
This product is not designed for use in life support appliances, devices, or
●
systems where malfunction of this product can reasonably be expected to re-
sult in personal injury. Aqua Computer GmbH & Co. KG customers using or
selling this product for use in such application do so at their own risk and
agree to fully indemnify Aqua Computer GmbH & Co. KG for any damages
resulting from such application!

3. 3. 3. 3. Scope of delivery

Scope of delivery Scope of delivery Scope of delivery
The following scope of delivery applies to the retail version only, product code
41118:
One D5 NEXT pump motor complete with detachable controller unit, sili-
●
cone damper (replacement part no. 94694) and mounting plate (replace-
ment part no. 94766)
One internal USB cable (replacement part no. 53215)
●
One mounting bracket, black (replacement part no. 94719)
●
One silicone insert (replacement part no. 94695)
●
Three screws M3 x 12 mm, countersunk head (replacement part no. 91149)
●
Three washers M3 (replacement part no. 91019)
●
Three hexagon nuts M3 (replacement part no. 91017)
●
Four screws M4 x 8 mm (replacement part no. 91007)
●
Four hexagon nuts M4 (replacement part no. 91053)
●
One manual
●

4. 4. 4. 4. Assembly instructions

Assembly instructions
Assembly instructions Assembly instructions
4.1. 4.1. 4.1.

4.1. Detachable control unit, mounting options

Detachable control unit, mounting options Detachable control unit, mounting options Detachable control unit, mounting options
The controller unit of the pump can be removed by pulling it off the pump motor
unit in a straight line. Make sure that no power is supplied to the pump whenever
the controller unit is being removed from or re-attached to the pump motor unit!
The controller unit can only be attached to the pump motor unit in a given orienta-
tion. Do not use excessive force but re-check the orientation if you encounter
problems re-attaching the controller unit.
The pump may be installed into the PC case using the supplied silicone damper
and mounting plate, either to a level surface or – using the supplied 90° bracket –
© 2019-2020 Aqua Computer GmbH & Co. KG
Gelliehäuser Str. 1, 37130 Gleichen
D5 NEXT
- 5 -