Display Configuration And Information; System Alarms; Display Settings - Aqua Computer D5 NEXT User And Installation Manual

D5 NEXT
ture sensors) or no fan speed signal is detected, an alarm will be raised if the
check box "Activate alarm evaluation" is set for this value.
While an alarm condition is detected, the pump display will permanently show a
corresponding information screen. If more than one alarm is active, the displayed
information will alternate between corresponding screens in short order. To
change the alarm configuration, you may still access the menu during alarm con-
ditions by pressing the middle key next to the display.
On the alarm page within the aquasuite, all sources that currently raise an alarm
are highlighted with a red background color. Alarms that have been active at least
once since pump start-up, but are not active presently, are highlighted with a yel-
low background color.
Make sure only to use readings for alarm evaluation that are functional with your
specific setup.
14.3. 14.3.

14.3. System alarms

14.3. System alarms System alarms System alarms
System alarms are raised for severe malfunctions and can not be configured. If a
system alarm is detected, the water cooling system will be either inoperational or system alarm is detected, the water cooling system will be either inoperational or system alarm is detected, the water cooling system will be either inoperational or system alarm is detected, the water cooling system will be either inoperational or
severely impaired, instant action (shutdown of the PC) is mandatory! The alarm severely impaired, instant action (shutdown of the PC) is mandatory!
severely impaired, instant action (shutdown of the PC) is mandatory! severely impaired, instant action (shutdown of the PC) is mandatory!
buzzer is activated whenever a system alarm is detected.
The following system alarms can be detected:
Supply voltage failure 12 V: Pump function not guaranteed, fan output func-
●
tion not guaranteed. Shut down PC immediately!
Supply voltage failure 5 V: Pump function not guaranteed, fan output func-
●
tion not guaranteed. Shut down PC immediately!
Pump speed failure: Pump function not guaranteed. Shut down PC immedi
●
ately! ately! ately! ately!
Fan current too high: Fan output deactivated. Shut down PC immediately!
●
Fan output short circuit: Fan output deactivated. Shut down PC immediately!
●
15. Display configuration and information pages 15. 15. 15. Display configuration and information pages Display configuration and information pages Display configuration and information pages
aquasuite: Select "Display" from the device list below the "D5 NEXT" en-
try.
Device menu: Select "Display" from the menu list and confirm by pressing
the middle key.
15.1.

15.1. Display settings

15.1. 15.1. Display settings Display settings Display settings
Units for temperature and flow measurement can be selected, display brightness
and page interval can be adjusted.
As with all OLED displays, the brightness of active pixels will reduce over time. For
a homogeneous wear of all pixels, the display can automatically be inverted half
of the time. In order to counteract existing wear, the inverted mode can be perma-
nently activated.
- 22 -
Shut down PC immediately!
Shut down PC immediately! Shut down PC immediately!
Shut down PC immediately! Shut down PC immediately! Shut down PC immediately!
Aqua Computer GmbH & Co. KG
Gelliehäuser Str. 1, 37130 Gleichen
aqua computer
Shut down PC immedi- - - - Shut down PC immedi Shut down PC immedi
Shut down PC immediately! Shut down PC immediately! Shut down PC immediately!
Shut down PC immediately! Shut down PC immediately! Shut down PC immediately!
© 2019-2020
If a If a If a