Step 5: Connect The Patient Cable - General Sleep Zmachine Insight Patient Manual

Step 5: Connect the Patient Cable

When you are in bed and ready to attempt sleep (not reading or doing any
other activity), plug the free end of the patient cable into the Zmachine.
The Zmachine will turn on automatically.
Connecting the Patient cable to the Zmachine
After starting, the Zmachine will automatically check the connection
between the sensor pads and your skin. If a sensor needs to be replaced,
and at least 30 minutes has passed since the sensor pads were applied,
simply remove, discard, and repeat the steps above using a fresh sensor
pad. Never re-use a sensor pad.
Note: One of the white sensor wires has two raised bumps on the snap
connector which can be felt with your finger tip, and the other is
smooth. These bumps are used to distinguish the wires during the
sensor check.
Hint: The Zmachine display will automatically dim and then turn off
while running. Pressing any button will wake the display for a
few seconds. The system continues to run while the display is off.
10
All Pass
→
Replace white wire with
2 raised bumps
Patient Guide