Replacing The Lamp - Epson EMP-7500 Owner's Manual

Replacing the Lamp

♦
54 Maintenance
Downloaded from:
3. The air filter is attached to the inside of the projector. To
clean the filter you are advised to use a small vacuum
cleaner designed for computers and other office
equipment.
If the dirt is difficult to remove or if the filter is torn,
replace it.
An air filter come with replacement lamps.
Contact your EMP-7500/ 5500 dealer or call an EPSO N
Service Centre.
Be sure to request part number. (ELPLP06)
4. Plug the power cable back into the wall socket.
The projector lamp typically lasts for about 2000 hours of use.
It is time to replace the lamp when:
• The projected image gets darker or starts to deteriorate.
• The projection lamp indicator (orange flashing).
• The message "LAMP REPLACE" appears on the screen
when the projector lamp comes on.
Contact your local EPSO N dealer for a replacement lamp.U se
only replacement lamp part number.(ELPLP06)
Caution: This projector lam p develops high heat and high
pressure during use, so the lam p (bulb) ruptures and burns m ay
result. To avoid serious injury, before attem pting to replace the
lam p, pull out the power cord plug from the outlet and wait for
the lam p (bulb) to cool (wait at least one hour). Then proceed to
replace lam p.
1. Turn off the projector and unplug the power cable.
2. Turn the projector over so you can access the lamp cover.
http://www.usersmanualguide.com/